Then, allow it to run for around 30 seconds so that it can collect data on the frame skips and calculate the number of NPCs. To reset it, just press Start+Up to hide and display the screen again. However, since I've had this screen up since the game began, I need to reset it as it's been taking note of frame skips from the beginning of the game. The way NPC count works for the plugin is that it calculates the highest frame jump and subtracts it by 1.

Starter Final Screen Image - Notice how the NPC Count says 8 Specifically for starters, it is the moment where you're holding up the Starter and the text says You chose Rowlet/Litten/Popplio! Usually for Gift Pokemon and a few other cases, this will a black box with text in it saying that you have obtained the Pokemon. Reaching the Final Screen and resetting NPC CountĮvery Pokemon is generated at a specific moment, which for the sake of consistency, we will call the Final Screen. You must input your initial seed each time you reboot your game and start a new RNG.Ģ. Once you're done with this section, your tool should look like this. If you then press Select+Left, it will show your TSV. This should open up the Party Pokemon menu. Once you're into the game, press Start+Right. TSV (Only necessary if going for a shiny) Overlay Image - Here you can see my initial seed is 0149CFAE. If it doesn't load up, try pressing Start + Up. You can immediately see your Initial Seed (this will go into the Seed in the 3DSRNGTool). Upon opening NTR and then booting up the game, the overlay should automatically load up. Fill these in first depending on what you want.Įxample Image - For the sake of the guide, I will be going for a shiny Rowlet on my Ultra Moon game. Using PokeCalcNTR, it is possible to find all of the necessary information. Upon opening the game and preparing the RNG, there are a few things that you will need to fill out (boxed in red) in 3DSRNGTool.

Install pcalc usum